AEM Series 2 Plug and Play EMS for Lexus GS300, SC300 and Toyota Supra
Series 2 Plug & Play Engine Management System
AEM's Series 2 EMS is a complete engine control system that plugs into the factory harness and uses the factory sensors. This means you do not need to replace any parts of the harness or sensors, just plug the EMS into the harness and begin tuning! The Series 2 EMS for the Lexus GS300 allows you to control every aspect of your 2JZ. From VVTi to rev limit, timing, bigger injectors, boost control, nitrous injection, individual cylinder fuel and timing trims and for you drag racers there's even anti-lag! Get total control for your GS300 with the Series 2 from our new tuning software - AEM Tuner.
Outputs | |
Injector Outputs | 12 Peak & Hold |
Coil Outputs | 6 |
Selectable direct drive or 0-5V Coil Output | Yes |
Direct plug in, no jumper harness required | Yes |
General purpose LS outputs | 11 |
General purpose HS outputs | 2 |
Individual cylinder ignition trims | Yes |
Individual cylinder fuel trims | Yes |
Inputs | |
Trigger inputs (Ref/Sync) | 4 |
Analog voltage inputs | 14 |
Configurable Analog/RTD/Thermister inputs | 4 |
Switch inputs | 5 |
Lambda inputs | 2x |
Knock sensors | 2 |
User adjustable knock sensor center frequency | Yes |
Communication | |
USB comms | Yes |
RS232 comms | Yes |
Communication cables included | Yes |
Fully enabled editing/logging software included | Yes |
CAN bus equipped | Yes |
RS232 datastream output | 19 ch |
CAN datastream output | 32 ch |
Communicates with AIM Dash/Dataloggers | Yes |
Communicates with Racepak Dash/Dataloggers | Yes |
DATA Acquisition | |
Internal data logging | 1 MB |
Maximum internal logging rate (per channel) | 250 Hz |
PC logging | Yes |
Data analysis using AEMLog | Yes |
Functions and Features | |
All channels/maps/tuning options unlocked | Yes |
Boost control | Yes |
Groundspeed based boost target | Yes |
Nitrous injection | Yes |
Staged injection | Yes |
Ground speed limiting | Yes |
Rate of Acceleration Control | Yes |
Overrun boost enhancement (anti-lag) | Yes |
Gear change ignition cut (shift-without-lift) | Yes |
Stepper motor idle control | Yes |
Password protected calibrations | Yes |
Fuel & Ignition rev limiters | Yes |
"In cockpit" global fuel trim capability | Yes |
Gear dependent shift light | Yes |
Evap/Purge function | Yes |
DC Motor control | 2 Ch |
Software definable "virtual" switch inputs | 2 |
EGT Based fuel trims | Yes |
Maximum boost limit | None |
Basic automatic transmission control | No |
Advanced automatic transmission control | No |
Physical Dimensions | |
Length | 203 mm |
Width | 178 mm |
Height | 41 mm |
Finish | Black Anodized |
This product fits the following vehicles:
- 1992 to 1997 Lexus GS300 3.0L I6
- 1992 to 1997 Lexus SC300 3.0L I6
- 1993 to 1997 Toyota Supra 3.0L I6 Cyl
AEMdata Data Analysis Software
AEMdata data analysis software is a custom data analysis package for select AEM products that features advanced 3D graphics and a user-friendly interface. It allows the user to review and playback vehicle, driver or engine data and overlay this data using charts, dash displays, gauges, or custom displays that you create. High-speed logging is saved to a file internally or via PC connection.
AEMdata IS THE INTEGRATED ANALYSIS SOFTWARE FOR THE FOLLOWING AEM PRODUCTS:
- AQ-1 Data Logger
- Water/Methanol Failsafe Device
- Wideband Failsafe Gauge
- Series 2 Programmable Engine Management System*
- EMS-4 Universal Standalone Programmable Engine Management System*
* Not all AEMdata features are supported in some AEM products.
CUSTOMIZABLE INTERFACE
AEMdata features a functional workspace that allows information to quickly be accessed. It is designed to be customizable by the user. From the layout interface to the gauge styles, it's your call! Users can also create tabs to data for quick reference and store them for future reference.
EASY TO SET UP AND CUSTOM DISPLAYS
All channels are listed in the AEMdata set up menu. Users simply drag and drop the channel that they want to analyze into the window and it will display.
Changing your display couldn't be easier with AEMdata! For instance, if a user selects a gauge set up for the display interface and wants to change a logged channel from oil pressure to fuel pressure, they simply grab the fuel pressure channel from the menu and drag it to the oil pressure gauge display. The program then changes the gauge from oil to fuel pressure.
DESIGNED FOR IMMEDIATE REFERENCE
In racing, the ability to quickly interpret vehicle conditions, track conditions and what the driver is doing can make the difference between a podium finish and a long trip home, which is why AEMdata was designed for immediate access to information.
With AEMdata, users are able to program definable color changes for parameters of logged channels. For instance, if you are logging water temp and have defined a temperature range, the logging trace can change color if it exceeds a defined setting, allowing users to quickly skim logged data for color changing peaks and valleys versus tracing the channel log to find where the problem occurred.
TRACK MAPPING
Vehicles equipped with a Vehicle Speed Sensor (VSS) and accelerometer can log this data to create track maps and overlay their logged channels data on track. Users can also add a 1HZ or 5Hz GPS with power and ground to achieve latitude and longitude channels, accelerometer, ground speed, etc. Either of these methods can be used to create track maps and GPS track maps can be exported to Google Earth to view your path in the "real World".
AEMdata also has the ability to add markers to a user's track map in the event a beacon is missed. This eliminates missed beacon counts that lead to inaccurate lap times.
POWERFUL
AEMdata has powerful features including custom math channels, x/y plots and histograms, stage or circuit modes and more, all aimed at making sure you get the most out of your data.
View complex sensors and devices such as the Dyno-Shaft On-Vehicle Dynamometer, 4-Channel Wideband UEGO Controller and more. AEMdata takes complex information, puts it right at your fingertips any time and allows you to analyze it in a format that is easy to use.
AEMdata FEATURES:
- Multi-tabbed, customizable workspace
- Drag and drop channel selection
- Smart data organization
- User-defined math channels
- Channel statistics include min/max values, start/end vales, time at start/end of range, time at sample min/max distance at start/end of range, min/max distance samples and more!
- User-defined reports
- Log playback mode
- Circuit or stage modes
- Multi-lane log trace
- cMultiple channels per lane
- Track mapping is available via VSS and G Analyst or with GPS in closed circuit or point-to-point
- Unlimited map overlays
- Lap/sector analysis
- Time/distance plots
- Alarm reports
- Analog-style and bar gauges
- X/Y plots
- Histograms
- 3D scatter plot
- Data export via .csv, Matlab, etc.
AEMTuner SOFTWARE
OVERVIEW
AEMTuner Software for the Series 2 Plug and Play EMS and EMS-4 Universal Standalone EMS is infinitely adjustable and allows tuners to program virtually any combination of engine control, power adders and auxiliary devices, and accurately delivers proper amounts of fuel and correct ignition timing for any boost level or operating condition. Professional tuners will appreciate the ease of use and security features of Advanced Engine Management's AEMTuner Software. AEMTuner software is Windows™ compatible (XP, Vista, Windows7), making the task of copying, viewing and manipulating data as simple as a click of the mouse.
KEY FEATURES
- Support Pane gives tuners context sensitive help and uses tuners' actual calibrations to describe each function.
- Maps can be password protected by the tuner to prevent unauthorized usage or sharing.
- Internal conflict detection notifies tuner if obvious errors exist in assignment of inputs/outputs.
- Compare Calibrations allows tuners to graphically compare tables and maps for easy analysis.
- Workspaces are easily customizable and configurable.
- Colored tables and maps.
- Data analysis using AEMdata software.
AEMTuner SCREENSHOTS
Τhe latest Versions of AEMTUNER
AEM Tuner Manual click here