AEM Series 2 Plug and Play EMS for Dodge Stealth and Mitsubishi 3000GT

Share
Control Rev Limit, timing, injectors, boost, nitrous and more
Rating:
100% of 100
Out of stock
Barcode
840879020439
SKU
30-6311
2,424.00€ 1,954.84€
AEM's Series 2 EMS is a complete engine control system that plugs into the factory harness and uses the factory sensors. This means you do not need to replace any parts of the harness or sensors, just plug the EMS into the harness and begin tuning! The Series 2 EMS allows you to control every aspect of your engine.

Series 2 Plug and Play EMS

30-6311_1
 

Series 2 Plug & Play Engine Management System

 

AEM's Series 2 EMS is a complete engine control system that plugs into the factory harness and uses the factory sensors. This means you do not need to replace any parts of the harness or sensors, just plug the EMS into the harness and begin tuning! The Series 2 EMS allows you to control every aspect of your engine. From rev limit, timing, adding different sized injectors, boost control, nitrous injection, even anti-lag and individual cylinder fuel and timing trims, the Series 2 EMS gives you total control from an easy to use interface.

 
Outputs
Injector Outputs 6 Peak & Hold, 8 Saturated
Coil Outputs 6
Selectable direct drive or 0-5V Coil Output Yes
Direct plug in, no jumper harness required Yes
General purpose LS outputs 12
General purpose HS outputs 4
Individual cylinder ignition trims Yes
Individual cylinder fuel trims Yes
Inputs
Trigger inputs (Ref/Sync) 4
Analog voltage inputs 18
Configurable Analog/RTD/Thermister inputs 4
Switch inputs 5
Lambda inputs 2x
Knock sensors 2
User adjustable knock sensor center frequency Yes
Communication
USB comms Yes
RS232 comms Yes
Communication cables included Yes
Fully enabled editing/logging software included Yes
CAN bus equipped Yes
RS232 datastream output 19 ch
CAN datastream output 19 ch
Communicates with AIM Dash/Dataloggers Yes
Communicates with Racepak Dash/Dataloggers Yes
DATA Acquisition
Internal data logging 1 MB
Maximum internal logging rate (per channel) 250 Hz
PC logging Yes
Data analysis using AEMLog Yes
Functions and Features
All channels/maps/tuning options unlocked Yes
Boost control Yes
Groundspeed based boost target Yes
Staged injection Yes
Ground speed limiting Yes
Rate of Acceleration Control Yes
Overrun boost enhancement (anti-lag) Yes
Gear change ignition cut (shift-without-lift) Yes
Password protected calibrations Yes
Fuel & Ignition rev limiters Yes
"In cockpit" global fuel trim capability Yes
Gear dependent shift light Yes
Evap/Purge function Yes
DC Motor control 2 Ch
Software definable "virtual" switch inputs 2
EGT Based fuel trims Yes
Maximum boost limit None
Physical Dimensions
Length 192 mm
Width 150 mm
Height 37 mm
Finish Black Anodized
 

This product fits the following vehicles:

  • 1992 to 1997 Dodge Stealth R/T 3.0L Turbo
  • 1991 to 1997 Mitsubishi 3000GT 3.0L Turbo
 
      

Infinity Engine Management Software

InfinityTuner Version: 2.86 File Size:12.3MB
InfinityTuner Wizards Version: 2.4 File Size:1.9MB
InfinityTuner Drivers Version: 2.81 File Size:2.98MB
InfinityTuner Layout Version: 2.81 File Size:4KB
InfinityTuner Session Version: 2.81 File Size:44KB
AEMdata Version:4.00.37 File Size:6.3MB

Series 1,Series 2 & EMS-4 Software

AEMTuner Series 2 EMS & EMS 4 Version: 2.98 File Size:32.4MB
AEMdata Version: 4.00.37 File Size:6.3MB

F/IC Calibration Software

F/IC - 8 Version: 1.05 File Size:18.9MB
F/IC - 6 Version: 3.04 File Size: 19.1MB
F/IC - 6 Patch Version: 3.05 File Size: 208KB
F/IC - 4 Version: N/A File Size: 19.2MB

AQ-1 Data Logger Software

AQ-1 Requires .Net
Framework 4 to be installed first

Version: 1.3 File Size: 11.1MB
AQ-1 Firmware update Version: N/A File Size: 308KB
.Net Framework 4 Version: N/A File Size: 869KB
AEMdata Version:4.00.37 File Size:6.3MB

Wideband Failsafe Config Software

WF Config Software Version:1.2.8.7 File Size:7.69MB
AEMdata Version: 4.00.37 File Size:6.3MB

Data Logging & Analysis Software

AEMdata Version: 4.00.37 File Size:6.3MB

Serial Cauge Config Software

Pro Gauge Version:N/A File Size:10.2MB
Write Your Own Review
You're reviewing:AEM Series 2 Plug and Play EMS for Dodge Stealth and Mitsubishi 3000GT
Your Rating
Customer Questions
What is the AEM Series 2 EMS?
The AEM Series 2 EMS is a complete engine control system that plugs into the factory harness and uses the factory sensors. It allows you to control every aspect of your engine, from rev limit and timing to boost control and individual cylinder fuel and timing trims.
What vehicles does the Series 2 Plug and Play EMS fit?
This product fits the 1992 to 1997 Dodge Stealth R/T 3.0L Turbo and the 1991 to 1997 Mitsubishi 3000GT 3.0L Turbo.
What are the outputs of the Series 2 EMS?
The Series 2 EMS features injector outputs, coil outputs, LS outputs, HS outputs, individual cylinder ignition and fuel trims, and more.
What communication options does the Series 2 EMS have?
The Series 2 EMS supports USB and RS232 communications, includes communication cables, and comes with fully enabled editing/logging software.
What are the data acquisition capabilities of the Series 2 EMS?
The Series 2 EMS has internal data logging, PC logging, and supports data analysis using AEMLog. It also has CAN bus and RS232 datastream output.